ETHANOL PRODUCER'S DATA BASE

Charles 803 Large piping

Compare Vapor Feeds

THROUGH WALLS OR BULKHEAD FITTINGS

Through-wall fittings, which are also known as bulkhead fittings, allow you to make safe, quick inlets and outlets in plastic and metal tanks, walls, and panels for faucets, pipes, and spigots.
To install: Cut or drill a hole in your tank, slide the body of the fitting through the hole from the inside of the tank exactly as per diagram at right and tighten the nut on the outside of the tank.

Source: McMAster catalog page 95 ( This link opens the Mc Master catalog, insert :Page 95 in the window at top left of page )

COPPER TUBE DATA

ABREVIATIONS

Unit Abbreviations

Ac	acre	kW	kilowatt
Af	acre feet	kWh	kilowatt-hour
amp	ampere	L	liter
°C	degrees Celsius	lb	pound
CFM	cubic feet per minute	lbs/sq in	pounds per square inch
CFS	cubic feet per second	m	meter
Ci	Curie	M	Mega
cm	centimeter	M	million
cu ft	cubic feet	mg	milligram
cu in	cubic inch	MGD	million gallons per day
cu m	cubic meter	mg/L	milligram per liter
cu yd	cubic yard	min	minute
°F	degrees Fahrenheit	mL	milliliter
ft	feet or foot	mm	millimeter
ft-lb/min	foot-pounds per minute	N	Newton
g	gravity	ohm	ohm
gal	gallon	Pa	Pascal
gal/day	gallons per day	pCi	picoCurie
GFD	Gallons of flux per square foot/day	ppb	parts per billion
gm	gram	ppm	parts per million
GPD	gallons per day	psf	pounds per square foot
gpg	grains per gallon	psi	pounds per square inch
GPM	gallons per minute	psig	pounds per square inch gage
gr	grain	RPM	revolutions per minute
ha	hectare	sec	second
HP	horsepower	sq ft	square feet
hr	hour	sq in	square inches
in	inch	W	watt
k	kilo
kg	kilogram
km	kilometer
kN	kilonewton

REFERENCES AND BIBLIOGRAPHY

TABLE SHOWING RELATIVE COLUMN SPECIFICATIONS

Although it is meant as a Packing material calculator

It is an excellent reference point for all the basic

parameters involved in a simple column design reference.

<SOURCE> http://homedistiller.org/refluxdesign.htm